Nxg-technology NX-RF200 Bedienungsanleitung

NX-RF200Installation ManualOptimizing NarrowBand Reception withComplete ControlRemotesNX-RF200_Manual.qxd 10/27/08 12:48 PM Page 1

Controlling Four Identical Components/Zones There are several considerations to take into account when you areinstalling an NX-RF200 to control an arr

By looking at the Signal column, you can see that the factory default pro-gramming sets all of the devices to send both IR and RF commands. If youlook

In the figure below, each device is set to a specific flasher.Note: Remember, the NX-RF200 will only respond to selections 1 through 4. Step 5 - Make

Programming For Multiple Equipment LocationsYou can operate up to 15 different equipment locations, each with an NX-RF200 assigned a unique Receiver I

USA Limited Warranty StatementYour NX-RF200, when delivered to you in new condition, is warrantedagainst defects in materials or workmanship as follow

Frequently Asked QuestionsCan I use flasher/emitters that I have already installed in the system toconnect to the NX-RF200?Yes, the flashers are compa

Information To The UserThis equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the FCC

NX-RF200 Installation Manual ©2008 NXG Technology.The information in this manual is copyright protected. No part of this man-ual may be copied or repr

Table Of ContentsIntroduction 1Features and Benefits 2Parts Guide 2Installation 3Testing 5Front Blaster Overload 6Disabling the Front Blaster - Ste

IntroductionThe NX-RF200 base station is an “addressable” base station. RF Addressing gives you the ability to control as many as 60 identical compone

Features and BenefitsInterference Rejection and Extended Range via Narrow BandThe NX-RF200 receives RF (radio frequency) signals via its integrated RF

1. Unplug the NX-RF200. Test all IR commands and macros line of sight. 2. Power on all AV components including the TV. Turn on all of the lightsand lo

NX-RF200 Base Station45. Observe the Status LED of the NX-RF200. If it is glowing or flickeringyou must relocate the NX-RF200 to a location where the

TestingTest a few commands for each device before fixing the flasher in place onthe front panel of a device.Since TiVo, Replay TV, Satellite Receivers

Front Blaster OverloadA few models of audio/video components can be overloaded by the FrontBlaster. If you are having intermittent or inconsistent res